Ultrasonic laboratory dispersion equipment uses physical technology to produce a series of near bad conditions in the medium of chemical reaction. This energy can not only stimulate or promote many chemical reactions and accelerate the speed of chemical reactions, but also change the direction of chemical reactions and produce some effects. It can be applied to almost all chemical reactions, such as extraction and separation, synthesis and degradation, biodiesel production, degradation of toxic organic pollutants, treatment of microorganisms, biodegradation treatment, biological cell crushing, dispersion and coagulation, etc.

So what should be paid attention to in the process of using ultrasonic laboratory dispersion equipment?

1. During maintenance, hang a “no operation” warning sign at the control lever. If necessary, warning signs shall also be hung around it. If someone starts the engine or pulls the lever, it will cause serious injury to the staff.

2. Only suitable tools can be used. The use of damaged, inferior or substitute tools will cause injury to operators.

3. Keep the equipment clean as a whole. Leaking hydraulic oil, oil, butter, tools and sundries may lead to accidents.

4. Shut down the engine before inspection and maintenance. If the engine must be started, the safety locking lever shall be placed in the locked position, and the maintenance work shall be completed by two people. The maintenance personnel shall be particularly careful.

5. Before maintenance and repair, all movable working devices shall be lowered to the ground position. The boom and stick angle should be maintained at 90 to 110 °, then lower the bucket with the bottom facing down, support the machine, and then support the machine with a safe support. If the machine is poorly supported, do not work under it.

Note: do not run without load, start or stop at a slow speed, and clean it after operation. The dispersion impeller under the dispersion shaft is a sawtooth impeller. The circumferential edge of the impeller is staggered up and down into a sawtooth shape, and its inclination angle is 20 ° ~ 40 ° along the tangent direction. When the impeller rotates, the vertical edge surface of each tooth can produce strong impact.